GENERAL PLASTICS MFG CO -- FRL-6700 LAST-A-FOAM PART A  -- 9330-00F049008
<pre>=====================  Product Identification  =====================

Product ID:FRL-6700 LAST-A-FOAM PART A
MSDS Date:03/13/1996
FSC:9330
NIIN:00F049008
Kit Part:Y
=== Responsible Party ===
Company Name:GENERAL PLASTICS MFG CO
Address:4910 BURLINGTON WAY
Box:9097
City:TACOMA
State:WA
ZIP:98409-2833
Country:US
Info Phone Num:206-473-5000
Emergency Phone Num:206-473-5000
CAGE:28014
=== Contractor Identification ===
Company Name:GENERAL PLASTICS MFG CO
Address:4910 BURLINGTON WAY
Box:9097
City:TACOMA
State:WA
ZIP:98409-2833
Country:US
Phone:206-473-5000
CAGE:28014

=============  Composition/Information on Ingredients  =============

Ingred Name:DIPHENYLMETHANEDIISOCYANATE (MDI), METHYLENE BIS
    (PHENYLISOCYANATE), 4,4 DIPHENYLMETHANE DIISOCYANATE (MDI)
CAS:101-68-8
RTECS #:NQ9350000
Fraction by Wt: 50%
Other REC Limits:0.005 PPM
OSHA PEL:0.02 PPM
ACGIH TLV:0.051 MG/CUM
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

Ingred Name:HIGHER OLIGOMERS OF MDI, POLYMETHYLENE POLYPHENYLENE
    POLYISOCYANATE
CAS:9016-87-9
RTECS #:TR0350000
Fraction by Wt: 50%

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:ORAL LD50(RAT): 10 G/KG
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INGESTION: IRRITATON OF THE MOUTH,
    PHARYNX, ESOPHAGUS & STOMACH. EYES: WILL CAUSE MODERATE TO SEVERE
    IRRITATION. SKIN: DERMATITIS & SENSITIZATION CAN DEVELOP AFTER
    REPEATED/PROLONGED CONTACT. INHALATI ON: VAPORS & AEROSOLS CAN
    IRRITATE EYES, NOSE, RESPIRATORY PASSAGES & CAN RESULT IN PERMANENT
    DECREASE IN LUNG FUNCTION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION.
Medical Cond Aggravated by Exposure:ASTHMA, BRONCHITIS, EMPHYSEMA, SKIN
    ALLERGIES & ECZEMA & ASTHMA LIKE RESPIRATORY SENSITIZATION.

=======================  First Aid Measures  =======================

First Aid:SKIN: REMOVE W/SOAP & WATER. EYES: IMMEDIATELY FLUSH W/PLENTY
    OF WATER FOR 15 MINS. INGESTION: GIVE 1/2 GLASSES OF WATER TO
    DRINK. DON'T INDUCE VOMITING. INHALATION: REMOVE TO FRESH AIR.
    OBTAIN MEDICA L ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:425F
Extinguishing Media:DRY CHEMICAL, CO2, FOAM, EXTENSIVE WATER SPRAY.
Fire Fighting Procedures:DURING A FIRE,
    4.4-DEPHENYLMETHANE-DIISOCYANATE VAPORS & OTHER IRRITATING &/HIGHLY
    TOXIC VAPORS MAY BE PRESENT. SCBA & FULL PROTECTIVE GEAR MUST BE
    USED.
Unusual Fire/Explosion Hazard:AT TEMPS GREATER THAN 400F THIS MATERIAL
    CAN REACT &/DECOMPOSE WHICH CAN CAUSE PRESSURE BUILDUP IN CLOSED
    CONTAINERS & EXPLOSIVE RUPTURE IS POSSIBLE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:WEAR PROTECTIVE EQUIPMENT & RESPIRATORY
    PROTECTION DURING CLEANUP. MIX W/AN ABSORBENT & TREAT W/A
    DECONTAMINATION SOLUTION. DISSOLVE & MIX THE ABSORBED AREA W/THE
    SOLUTION TO OBTAIN A WET TO DAMP SLUR RY, ALLOW IT TO REACT FOR AN
    HOUR. (SEESUPP)
Neutralizing Agent:DECONTAMINATED SOLUTION: 3-8% AMMONIA IN WATER. 5-10
    SODIUM CARBONATE.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN TIGHTLY SEALED CONTAINER TO
    PROTECT FROM ATMOSPHERIC MOISTURE. NEVER SEAL A CONTAINER THAT MAY
    BE CONTAMINATED.
Other Precautions:REACTION W/WATER WILL PRODUCE CO2 WHICH WILL
    PRESSURIZE CONTAINERS. PREVENT SKIN & EYE CONTACT. AVOID BREATHING
    VAPORS/AEROSOLS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF NECESSARY, USE A NIOSH APPROVED POSITIVE
    PRESSURE SUPPLIED AIR RESPIRATOR. FOR EMERGENCIES USE A SCBA.
Ventilation:IS SUFFICIENT TO KEEP VAPORS BELOW THE TLV AT ROOM TEMPS.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY GLASSES/GOGGLES/FULL FACE SHIELD
Other Protective Equipment:PROTECTIVE APRONS, EYE WASH STATION.
Supplemental Safety and Health
KEY1:N1. SHOVEL MIX TO AN OPEN CONTAINER. DON'T SEAL THE CONTAINER,
    ALLOW THE REACTION TO GO TO COMPLETION OVER 48 HOURS/MORE. CO2 WILL
    BE EVOLVED, LEAVING INSOLUBLE POLYUREAS. THIS PHYSICAL PROPERTIE S
    IS FOR 4.4 DEPHENYLMETHANE-DIISOCYANATE.

==================  Physical/Chemical Properties  ==================

HCC:N1
Boiling Pt:B.P. Text:406F
Vapor Pres:<0.0001
Vapor Density:8.5
Spec Gravity:1.24
Solubility in Water:INSOLUBLE
Appearance and Odor:DARK BROWN LIQUID W/A SLIGHT MUSTY ODOR

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
WATER, ALCOHOL, AMMONIA, BASES & ACIDS, ALKALINE MATERIALS & SOME METAL
    COMPOUNDS.
Stability Condition to Avoid:MOISTURE
Hazardous Decomposition Products:TEMPS >400F.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
    REGULATIONS. SOLID NOR THE LIQUID PORTION IS A HAZARDOUS WASTE
    UNDER RCRA 40.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.